Sign in to save a design.
A Gridfinity bin. The file is an STL in millimeters, ready for a slicer.
Up to four holes. X and Y are measured from the center of the plate.
The base is the bottom leg. The rise is the upright.
Top corners are on the upright. Bottom corners are on the outer edge of the base.
Starts on the bottom and extends down, or on the top and extends up. Hole depth runs from the end of the shaft. Add the base thickness to go through the plate. Inside 0 is solid.
Bottom is the outer face. Top meets the shaft.
Up to four holes. X and Y are measured from the center of the plate.
The top plate sits on the end of this shaft.
A hollow shaft keeps this wall and a hole through both plates.
Bottom meets the shaft. Top is the outer face.
Up to four holes. X and Y are measured from the center of the plate.
The next row sits higher and farther back.
Every row uses the same bend, so a pen stays straight through the holes.
Set the inside diameter to 0 for a solid shaft.
83.5 × 83.5 × 46.4 mm
42 mm tall, plus a 4.4 mm stacking lip.