Sign in to save a design.
A Gridfinity bin. The file is an STL in millimeters, ready for a slicer.
Up to four holes. X and Y are measured from the center of the plate.
Bottom is the outer face. Top meets the shaft.
Up to four holes. X and Y are measured from the center of the plate.
The top plate sits on the end of this shaft.
A hollow shaft keeps this wall and a hole through both plates.
Bottom meets the shaft. Top is the outer face.
Up to four holes. X and Y are measured from the center of the plate.
The next row sits higher and farther back.
Every row uses the same bend, so a pen stays straight through the holes.
Set the inside diameter to 0 for a solid shaft.
83.5 × 83.5 × 46.4 mm
42 mm tall, plus a 4.4 mm stacking lip.